USING SLAVE RECEPTACLE TO START ENGINE

TM-9-2320-260-10
Page Navigation
114

TM 9-2320-260-10 2-18. USING SLAVE RECEPTACLE TO START ENGINE CAUTION Check condition of batteries before slave starting of engine. a. Position right side of slaving (recharging) vehicle to the right side of vehicle needing battery jump. b. Stop slaving vehicle engine. CAUTION When slaving, always connect slave cable to disabled vehicle first. Damage to batteries or cable may result from improperly connecting hot batteries before connecting cable to receptacle of disabled vehicle. NOTE Make sure electrical switches on both vehicles are in OFF position. c. Remove cover (8) from slave receptacle (9) and connect slave cable (10) to slave receptacle (9) on disabled vehicle. Repeat procedure on slaving vehicle. d. Start slaving vehicle engine and set idle speed at 1,000-1,100 rpm. e. Start slaved vehicle engine. f. After engine starts and is running smoothly, disconnect slave cable (10) from both vehicles. g. Put cover (8) back on receptacle (9). h. Clean and stow slave cable (10). i. Observe battery-generator indicator (11) on slaved vehicle, If indicator (11) is not in green area, notify organizational maintenance. TA 094298 2-83

Privacy Statement
Press Release
Contact