TM 9-2320-272-10
2-21.
RAISING WINDSHIELD AND INSTALLING CAB TOP
NOTE
This operation is best accomplished by the operator and one crew member.
a.
Release windshield catches (3) and raise windshield frame (1) to vertical position.
b.
Tighten knobs (4) on left and right sides of windshield frame (1).
c.
Secure windshield catches (3) to hood (2) mounts.
d.
Lower cab windows.
e.
Install two pillar posts (5) in rear corners of cab (10).
f.
Insert crossbow (8) in roof rail bows (6) and crossbow (7) with stave holes in curved portion of pillar posts
(5).
g.
Insert roof rails (12) on pillar posts (5) and windshield frame (1) and push roof rail catch (11) into
windshield frame (1) to lock catch (11).
h.
Install overhead staves (14) by placing washer end of staves (14) in windshield frame (1) and other end in
top crossbow (7).
i.
Place tarpaulin top (13) on hood (2) of vehicle, and slide front edge of cab top (13) sideways into
windshield channel (15) from either side of windshield frame (1).
j.
Pull tarpaulin top (13) towards rear of cab (10) over windshield frame (1), overhead staves (14), and
crossbows (7) and (8). Place inner flap of cab top (13) between seats (9) and inside of cab (10).
k.
Slide right and left edge of tarpaulin top (13) in right and left pillar post channels (20) and pull cab top (13)
down to back of cab (10). Make sure inner flap of tarpaulin top (13) slides behind seats (9) evenly.
l.
Secure top edge of tarpaulin top (13) to roof rail (12) with turn-button fasteners (16).
2-114
