TM 9-2320-272-10
3-11.
WHEELS AND TIRES (Contd)
(f)
Remove tape from hub body (1).
Remove adapter (4), O-ring (3), and washer (2) from
temporary storage on the wheel valve (5), and install in
hole in hub body (1).
(g)
Install hose assembly (11) on turret
valve (16) and hand-tighten.
(h)
Install wheel valve (5) on adapter (4).
Tighten adapter nut (15) and hose assembly (11).
(i)
Install shield (6) on wheel valve (5)
with two nuts (8) and washers (7), and on hub cap (18)
with two screws (10) and washers (9).
(j)
Start vehicle and select desired CTIS
mission mode.
NOTE
Check replaced tire to ensure
tire inflates automatically.
Report tire change to unit
maintenance as soon possible.
Most
screws
will
require
torquing to specific limits, and
O-ring seal will have to be
replaced.
(k)
Return
CTIS
tools
to
tool
compartment.
(l)
Secure damaged tire in spare tire
carrier.
d.
Tire Inflation.
(1)
General. Never decrease pressure of warm tires (17) except for operation in snow, sand, or mud (para. 2-
33, 2-35, or 2-37). After operations are completed, reinflate tires (17) to recommended pressure (refer to table 1-10).
3-52
