TM 9-2320-366-10-1
b. Raising Cab Protector.
WARNING
Cab protector is spring loaded and weighs approximately 180 lbs
(82 kgs). Hold cab protector down before removing pins. Slowly
allow cab protector to raise to upright position after pins are
removed. Failure to comply may result in injury to personnel.
NOTE
This task applies to both sides of cab protector. Left side shown.
(1) Remove lynch pin (1) from hitch pin (2).
(2) Remove hitch pin (2) from cab protector (3) and dump body (4).
(3) Install hitch pin (2) and lynch pin (1) in cab protector (3).
(4) Remove lynch pin (5) and turn bolt (6) from nut (7).
2-383
