TM 9-2320-260-10
FOR TURN SIGNALS, MOVE MAIN
SWITCH TO EITHER SERVICE DRIVE OR
STOP LIGHT POSITION. MOVE TURN
SIGNAL CONTROL LEVER UP FOR
RIGHT TURN AND DOWN FOR LEFT
TURN. MOVE TO NEUTRAL TO DEACTI-
VATE TURN SIGNALS.
NOTE
WHEN THE HAZARD WARNING
LIGHTS/EMERGENCY FLASHERS ARE
IN USE, THEY OVERRIDE THE BRAKE
LIGHT/STOP LAMP OPERATION,
THEREFORE, IF YOU ARE DRIVING
WITH THE HAZARD WARNING
LIGHTS/EMERGENCY FLASHERS
OPERATING, EXERCISE EXTRA CARE
AND BE PREPARED T0 UTILIZE HAND
SIGNALS TO INDICAIE A STOP.
2-15. PLACING AND SUSTAINING VEHICLE IN MOTION
NOTE
The vehicle cannot be moved until the transfer selector lever (2) is
in the HIGH (up) or LOW (down) position. Gearshift lever (1)
positions do not in any way affect selection of the transfer range
(LOW or HIGH) to be used. The transfer L.OW range provides
more power and lower speed in the five forward transmission
speeds, for heavy loads or difficult terrain conditions. The transfer
HIGH range provides greater speed at lower power to the five
forward transmission speeds for normal load and road conditions.
a. Be sure all auxiliary equipment and
tools are locked and stored for travel.
b. Adjust operator’s seat as required.
c. Start engine. Refer to paragraphs 2-12
and 2-13 as required.
TA 094292
Change 1 2-77
