TM 9-2320-260-10
g. Insert roof rail bows (8) of opposite
pillar post (7) into crossbows (9) and (11),
and install pillar post (7) in rear corner of
cab (12). Position roof rail (6) to windshield
(1) frame and push roof rail catch (5) into
windshield (1) frame to lock catch (5).
h. Place cab top (13) on hood (2) of
vehicle, and slide front edge of cab top (13)
sideways into windshield channel (14) from
either side of windshield (1).
m. Thread rope (20) through cab top (13)
holes and around lashing hooks (19). Tie
ends of rope (20) to last lashing hook (19)
on each side of cab (12).
n. To remove cab paulin top (13), reverse
steps e. through m.
Do not fold or stow paulin top
when wet. Damage to paulin will
result.
o. Clean and fold paulin top (13). Refer
to paragraph 2-8 for paulin cleaning
procedures.
p. When not in use, place crossbows (9)
and (11) and pillar posts (7) in folded paulin
top and stow under companion seat.
i. Pull cab top (13) towards rear of cab
(12) over windshield (1), and crossbows (9)
and (11). Place inner flap of cab top (13)
between seats (10) and cab (12) wall.
j. Slide right and left edge of cab top ( 13)
in right and left pillar post channels (21) and
pull cab top down to back of cab ( 12).
Make sure inner flap of cab top 13) slides
behind seats (10) evenly.
k. Secure top edge of cab top (13) to roof
rail (6) with turn-button-fasteners (18).
l. Remove retaining clip (15) and pin (16)
from roof rail bow (8) and push movable
crossbow (11) outward to take up slack of
cab top (13). Push pin (16) through roof rail
bow (8) and bracket (17) holes, and push
retaining clip (15) through hole in pin (16).
TA 094310
Change 1 2-95
