TM 9-2320-260-10
(c) Remove retainer clips from L.-shaped pins (3) and remove pins (3).
(d) Grasp outrigger base (5) and pull out all the way.
(e) Swing outrigger base (5) down to the ground.
(f) Install L.-shaped pin (3) in frame (7) and secure with retainer clips.
(g) Insert outrigger handle (6) into hole in outrigger collar (4) and turn collar (4)
until base (5) encounters pressure against the ground. Make sure outrigger is straight up
and down with base.
(h) Start engine (refer to paragraphs 2-12 and 2-13).
(j) Place gearshift lever (10) in
“4” (fourth) gear (14).
(k) Move power divider control lever
lock (13) to unlocked position and push
power divider control lever ( 12) down to
engaged position. Release clutch pedal (8)
slowly.
(i) Depress clutch pedal (8) all the
way and place transfer selector lever ( 11) in
“N” (neutral) position.
(l) Press electric brake lock button
(15) and hold. Depress service brake pedal
(9) down all the way and release. Release
brake lock switch button ( 15).
NOTE
Brakes are now locked in place and remain locked until brake
pedal is depressed and released again.
TA 094365
Change 1 2-151
