TM 9-2320-260-10
CAUTION
Shipper brace must be used for traveling or for lifting heavy loads
without swinging boom. Braces are used to prevent damage to
boom.
(s) Remove T-shaped pins ( 10) in braces (9). Raise or lower boom to remove
pressure on pins.
(t) Move boom control lever (8) to UP position to raise boom (7).
WARNING
Do not raise shipper brace beyond third hole from bottom.
Equipment failure can result in injury or death.
(u) Aline holes at desired length in brace and secure with pins (10).
(v) Join end braces (9) with brace bracket (12) and secure with pins (1 1).
NOTE
If more height is needed than full length of shipper braces allow,
use boom jacks. Refer to d., step 4 for installation of boom jacks.
(w) Lower boom (7) by moving boom control lever (8) to DOWN position.
TA 094367
2-153
