Retracting Van Body. -cont - TM-9-2320-260-10

Retracting Van Body. -cont - TM-9-2320-260-10_230

Retracting Van Body. -cont - TM-9-2320-260-10_232

TM-9-2320-260-10
Page Navigation
219

TM 9-2320-260-10 (16) From outside van, push upward and inward to fully close hinged floor (11) and roof panels (8). Turn lock handle (17) clockwise to lock floor and roof panels in closed position. (17) Remove holding rods (10) from end panels (9) and insert each rod into retaining clips on beam. (18) Close end panels (9) at all corners. (19) Turn left ratchet (2) clockwise with ratchet wrench (6) to retract right side panel (16). Crank both sides until fully retracted. Push locking plunger (1) upward to lock ratchet (2). (21) Insert end of lock handle assembly (22) into lockrod brace (20). Close lock handle assembly (22) and secure in place with chained pin (21). (20) Turn four side locks (18) clockwise with side panel lock wrench (19). (22) Remove two jack spikes (26) from footpad (27) and install jack handle (24) in leveling jack (25). Rotate jack handle (24) clockwise until footpad (27) clears ground. (23) Remove leveling jack (25) from van body bracket (23) and detach footpad (27) from jack. (24) Remove leveling jack chained pin (28) and slide telescoping jack tube into main jack tube. Reinsert chained pin. (25) Repeat steps 22 through 24 with remaining van body leveling jacks. (26) Stow leveling jacks (25), footpads (27), and jack spikes (26) in compartment at rear of van body. TA 094401 2-187

Privacy Statement
Press Release
Contact