TM 9-2320-366-10-1
APPENDIX F
LUBRICATION ORDER
Section I. INTRODUCTION
F-1. GENERAL
This appendix gives lubrication requirements for the vehicle which are the responsibility of
the Operator/Crew.
a. Adherence. Intervals (on-condition or hard time) and the related man-hour times are
based on normal operation. The man-hour time specified is the time needed to do all the
services prescribed for a particular interval. On-condition (OC) oil sample intervals shall
be applied unless changed by the Army Oil Analysis Program (AOAP) laboratory. Change
the hard time interval if lubricants are contaminated or if operating the equipment under
adverse operating conditions, including longer-than-usual operating hours. The calendar
interval may be extended during periods of low activity. If extended, adequate preservation
precautions must be taken. Hard time intervals will be applied in the event AOAP
laboratory support is not available. Hard time intervals must be applied during the
warranty period.
Intervals shown in this appendix are based on mileage/calendar times. The lubrication for
the vehicle is to be performed at whichever interval occurs first.
WARNING
Dry Cleaning Solvent (P-D-680) is TOXIC and flammable. Wear
protective goggles and gloves; use only in well-ventilated area; avoid
contact with skin, eyes, and clothes, and do not breath vapors. Keep
away from heat or flame. Never smoke when using Dry Cleaning
Solvent; the flashpoint for Type I Dry Cleaning Solvent is 100°F
(38°C) and for Type II is 138°F (50°C). Failure to comply may result
in serious injury or death to personnel.
If personnel become dizzy while using Dry Cleaning Solvent,
immediately get fresh air and medical help. If Dry Cleaning Solvent
contacts skin or clothes, flush with cold water. If Dry Cleaning
Solvent contacts eyes, immediately flush eyes with water and get
medical attention. Failure to comply may result in serious injury or
death to personnel.
b. Cleaning Fittings Before Lubrication. Clean parts with Dry Cleaning Solvent (SD
P-D-680) or equivalent. Dry before lubricating. Dashed arrows indicate lubrication on both
sides of the equipment.
F-1