TM 9-2320-260-10
Table 3-1. Troubleshooting (Cont'd)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
56. ENGINE OIL SHROUD NOT RECEIVING HEAT (ENGINE COOLANT HEATER ONLY).
Step 1.
Check to see if coolant heater is operating. (Refer to paragraph 2-43.)
Start beater. If inoperative, notify organizational maintenance.
Step 2.
Check to see if coolant heater exhaust tube is disconnected from oil pan shroud.
If disconnected, notify organizational maintenance.
57. ENGINE COOLANT SYSTEM NOT RECEIVING HEAT (ENGINE COOLANT HEATER ONLY).
Step 1.
Check to see if coolant heater is operating. (Refer to paragraph 2-43.)
Start heater. If inoperative, notify organizational maintenance.
Step 2.
Check to see if one or more shutoff cocks are closed at engine or coolant heater.
Open coolant shutoff cock(s).
A-FRAME KIT
58. WINCH INOPERATIVE.
Check winch.
See malfunction 29.
59. A-FRAME INOPERATIVE OR MISALINED.
Step 1.
Check to see if cable is secured in towing pintle.
If not, secure cable in towing pintle and lock pintle in closed position.
Step 2.
Check for loose cable clamps and frays or breaks in cable.
If loose cable clamps and frays or breaks in cable, notify organizational maintenance.
Step 3.
Check to see if A-frame is bent.
If A-frame is bent, notify organizational maintenance.
SLAVE RECEPTACLE
60. SLAVE CABLE CONNECTED BUT ENGINE WILL NOT TURN OVER.
Step 1.
Check for poor receptacle connection.
Make proper connection.
Step 2.
Check if slave receptacle battery cables are loose or disconnected.
If loose or disconnected, notify organizational maintenance.
WINDSHIELD WASHER KIT
61. WASHER INOPERATIVE.
Step 1.
Check windshield washer fluid level in reservoir.
Fill as required.
Step 2.
Look for broken, loose, or restricted tubing.
Notify organizational maintenance.
3-13
