TM 9-2320-272-10
2-16.
STOPPING THE VEHICLE AND ENGINE (Contd)
f.
Turn vehicle light switch (1), ignition switch (3), and battery switch (2) to OFF position.
CAUTION
Pull out EMERGENCY ENGINE STOP control if engine continues to run
after ignition and battery switches are in OFF position. Do not attempt to
restart M939/A1 series vehicle engine until unit maintenance has reset fuel
cutoff valve.
g.
Perform AFTER operation checks and services (table 2-3).
2-17.
USING SLAVE RECEPTACLE TO START ENGINE
a.
Position right sides of both vehicles together.
b.
Stop slaving vehicle engine.
c.
Pull covers (6) from slave receptacles (7) of disabled vehicle and slaving vehicle. Receptacle (7) is
located below grab handle (5).
CAUTION
Always connect slave cable to disabled vehicle first. Damage to batteries
or cable may result from improperly connecting cables.
d.
Connect slaving cable (8) between disabled vehicle and slaving vehicle.
NOTE
Ensure all unused electrical switches in both vehicles are off.
e.
Start slaving vehicle engine (para. 2-12).
f.
Start disabled vehicle engine.
g.
After disabled vehicle engine starts, disconnect slaving cable (8) from both vehicles.
2-108
