TM 9-2320-272-102-31.CTIS OPERATION UNDER UNUSUAL CONDITIONS (Contd)b.The selector panel (1) is part of the Electronic Control Unit (ECU) (4) and contains selectors for the fourpreset tire pressure modes and a run flat selector. Each selector has its own light. A steady selector light shows that thetire pressure selected has been achieved. A flashing selector light means that the system is working to change tirepressures (para. 3-5).c.HWY Mode. The highway tire pressure selector is the normal operating mode of CTIS. The HWY mode (8)is 60 psi (414 kPa) (80 psi (552kPa) for M936A2 wrecker). If a lower tire pressure mode had been selected the last timethe vehicle was operated, CTIS will automatically begin to inflate to the highway setting.d.X-C Mode.The cross-country tire pressure selector X/C (7) is used for operating the vehicle on non-pavedsecondary roads and unimproved surfaces. It allows operation up to 35 mph (56 km/h) (25 mph (40 km/h) on M936A2wrecker). When 35 mph (56 km/h) is exceeded for more than one minute, the amber overspeed warning light (2) will flash.If 35 mph (56 km/h) is exceeded for more than two minutes, CTIS will automatically begin to inflate to HWY (8) mode.e.Sand Mode. When the mission requires maximum traction in sand, snow, or mud select SAND (6) onselector panel (1). It allows operation up to 20 mph (32 km/h) (15 mph (24 km/h) on M936A2 wrecker). When 20 mph (32km/h) is exceeded for more than one minute, the amber overspeed warning light (2) will flash. If 20 mph (32 km/h) isexceeded for more than two minutes, CTIS will automatically begin to inflate to X/C (7) pressure.2-202
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business