TM 9-2320-260-10
(14) Remove midships winch cable
chain (2) from reach support tube (1) at
bolster trailer rear.
CAUTION
Do not disengage transfer power
takeoff lever (5) when transfer
selector lever (4) is operating in
“N” (neutral). This could cause
transfer bearing failure.
(15) With engine running, depress
clutch pedal (6) and place gearshift lever (3)
in “3” (third) gear position (7). Place trans-
fer selector lever (4) in “N” (neutral) posi-
tion. Pull transfer power takeoff control
lever (5) up as far as it will go to engaged
position. Release clutch pedal (6) and begin
rewinding midships winch cable (2).
(18) Remove ramps (11) and place on
catwalk (15) over midships winch. Secure
ramps (11) in stowed position by pushing
L-bolts (14) up through retaining slots (24)
in ramps (11). turning L-bolts (14) 90 de-
grees. grasping ring (13) and turning handle
(12) clockwise to tighten.
(16) Stop rewind as cable chain (2)
nears midships winch by disengaging engine
clutch (6) and shifting transfer power takeoff
control lever (5) down to disengaged
position. Place gearshift lever (3) in
“N" (neutral) position and release clutch
pedal (6). Attach winch cable (2) to fifth
wheel base.
(17) Disengage winch drum clutch by
pushing drum clutch lever ( 10) toward winch
as far as it will go. then swing hinged lock
(9) down. Lock winch drum by pulling drum
lock knob (8) out, rotating it 90 degrees.
alining lock plunger with one of holes in
drum flange. and releasing knob (8).
2-108
