TM 9-2320-260-10
(2) Positioning the Crane Supports.
(a) Install outrigger base plates (4)
on rear outriggers (2) and secure with
retaining pin (1) and lockpin (3).
(b) Remove L-shaped pin (8), grasp outrigger base plate (4), and swing outrigger
(2) down to touch ground.
(c) Install L-shaped pin (8) in end frame (9).
(d) Use handle (7) to turn outrigger collar (6) left or right, as required, to rest base
plate (4) flat on ground; continue turning until pressure is felt when base plate (4) touches
ground. Repeat procedures for three remaining outriggers (2).
(e)
NOTE
Make sure outrigger (2) stands straight when resting against
ground.
Secure shipper braces in travel position (refer to step 6, i through m above).
2-166
