Table 2-2.
NOTE
TM 9-2320-260-10
Operator/Crew Preventive Maintenance Checks and Services (Cont’d)
These checks are to be made in the order listed, within designated interval.
B-Before operation D-During operation
A-After operation W-Weekly M-Monthly
ITEM
NO.
INTERVAL
ITEM TO BE INSPECTED
PROCEDURE: Check for and
have repaired, filled, or
adjusted as needed
for proper operation. They are: cable tensioner valve
b. While operating rear winch, check all controls
(4), throttle control lever (5), winch shift control (6),
clutch control lever (8), and shift lever lockpin (7).
c. Inspect hose assemblies for leaks.
WRECKER CRANE
l Before opening reservoir, make sure area
around reservior cap is clean. Do not allow
dirt, dust, or water to enter reservoir.
. Do not proceed with crane operation if oil
level is less than halfway from end of dipstick
to full mark. Fill as needed.
a. Before using crane, remove reservoir cap and
lipstick (10) and measure reservoir oil level. Add oil
as required.
EQUIPMENT IS
NOT READY/
AVAILABLE IF:
Any controls are
inoperative,
Class III leak is evident.
b. While operating crane, check filter indicator (9 I
m front of crane oil reservoir. Filter should point to
clean. If not, notify your supervisor.
c. Check brake lock switch (13), floodlights and
switch (12), amber warning light on left front fender,
and signal light switch (11) for proper operation.
d. Inspect all hydraulic lines, hoses, and fittings
‘or leaks, abrasions and damaged fittings.
Class III leak is evident.
TA 094270
Change 1 2-55
